Komar Industries - York

Overview

The MIG Welder position involves building subassemblies for compactors and balers while adhering to quality and safety standards. The starting pay rate is dependent on skill level, which is assessed through a weld test.

Responsibilities

• Build subassemblies for compactors and/or balers utilizing existing fixtures.
• Weld to acceptable quality expectations on all weld positions (flat, down, over).
• Assemble and weld sides, floors, and dog boxes on compactors.
• Assemble and weld sides, floors, tops, doors, and wire gates on balers.
• Meet production standards.
• Maintain good attendance record and work overtime as needed.
• Maintain good safety record.
• Maintain a positive attitude.
• Position parts together using clamps, tack welds, and layout marks.
• Position parts at various levels including floor, table, shoulder, and above shoulder.
• Stand, walk, talk, and hear.
• Reach with hands and arms.
• Climb, balance, stoop, kneel, crouch, or crawl.
• Regularly lift and/or move up to 10 pounds, frequently lift and/or move up to 50 pounds, and occasionally lift and/or move up to 100 pounds.

Requirements

• Experienced MIG welder.
• Requires supervision.
• Can read basic blueprints or drawings.
• Ability to use a tape measure.
• High school diploma or GED or relative experience/training.
• Ability to read and comprehend simple instructions, short correspondence, and memos.
• Ability to write simple correspondence.
• Ability to effectively present information in one-on-one and small group situations.
• May require basic math and/or tape measure reading.
• May require ability to add, subtract, multiply, and divide in all units of measure.
• Ability to apply common sense understanding to carry out detailed instructions.
• Ability to deal with problems involving a few variables in standardized situations.

Benefits

• Health Insurance
• Vision
• Dental
• 401k
• Life Insurance