Fluor Corporation

Overview

At Fluor, we are committed to fostering a welcoming and collaborative work environment that encourages big-picture thinking and innovative solutions. We invite you to apply for the Boilermaker role, where you will be involved in various tasks related to fabrication and installation.

Responsibilities

• Follow all health, safety, and environmental requirements.
• Perform cleanup duties.
• Perform material handling and storage duties.
• Identify, use, and care of common hand and power tools.
• Use and care of craft specific tools and equipment.
• Knowledge and application of craft related mathematics.
• Knowledge and use of safety standards and best safety practices relevant to rigging.
• Inspect rigging equipment and hardware.
• Knowledge and application of common hitches and emergency stop signals.
• Perform basic procedures for using various slings in hitches and calculating sling stress.
• Utilize tools and equipment for the lateral movement of loads without a crane.
• Knowledge of wire rope components and inspection requirements.
• Perform oxyfuel cutting operations.
• Fabricate and install gaskets.
• Identify and select pipe fittings.
• Perform material cutting operations.
• Perform bolt make-up.
• Perform weld preparation and set-up.
• Perform layout and fabrication duties.
• Structural and tube fit-up and alignment.
• Perform base metal preparation.
• Perform preheat and post-weld heat treatment operations.
• Perform vessel inspection.
• Install valves and components.
• Identify, fabricate, and install pipe hangers and supports.
• Fabricate and install stairs, railings, grating, and decking.
• Review construction drawings and blueprints for specifications.
• Cut and thread pipe manually.
• Read and interpret welding detail drawings.
• Perform boiler tube fabrication, preparation, and fitting.
• Perform air carbon arc cutting and gouging.

Requirements

• Understand and carry out oral instructions.
• Read and carry out written instructions to perform work tasks.
• Work at varying heights.
• Recognize, avoid, and report safety hazards.
• Assemble and disassemble objects.
• Operate equipment and power tools.
• See hazards, safety warnings, and barriers.
• Bend knees for lifting and routine work tasks.
• Stoop for work positioning and lifting.
• Lift maximum 50 lbs without assistance.
• Ability to comprehend and respond to audible/visual instructions, alarms, and warnings.
• Climb/balance on ladders, scaffolding, and structures.
• Kneel for work positioning and task performance.
• Reach above shoulders and away from body to perform work tasks.
• Demonstrate manual dexterity to perform work tasks.

Additional Information

• Work in extreme heat or cold.
• Work where noise level is above 85 decibels.
• Work in wet/humid environment.
• Work in cramped quarters.
• Work in environment of fluctuating ventilation.
• Work inside and outside.